Juniper-systems Allegro DOS Manual Manual do Utilizador descarregar pdf (Página 166)

Page 5-6 MS-DOS

<F3>, <F4>, <F5>: When the Allegro is communicating with Lynx on

the desktop computer, the FileScout Transfer functions F3, F4, and F5

are not used.

<F6> Lynx: To communicate with Lynx, the Allegro needs to be in the

Lynx communication mode. When Lynx mode is on, the word "Lynx"

is displayed at the top of the FileScout menu along with the active

port as shown below:

FileScout v1.0 Lynx – COM1

When the Allegro is in Lynx mode, it checks at regular intervals to see

if it is linked to a computer. When it detects a connection, the Allegro

is treated as a remote computer by the desktop computer. To turn

Lynx mode on or off, Press <F6> and make a selection.

❖ Note: To use Auto Suspend, you must turn Lynx mode off. See System Setup

Program, Power Management Screen, and Auto Suspend later in this section of

the manual for details.

Communicating with Other Desktop PC Programs

Some programs have integrated PC communication modules you will

use instead of Lynx. DataLink and LandMark PC are two examples.

The FileScout Transfer screen has three functions that you may use with

these programs: <F3> Command, <F4> Receive, and <F5> Send. Refer to

the User's Manual for the program you are using for information on

how to proceed.

1 2 ... 161 162 163 164 165 166 167 168 169 170 171 ... 273 274

Sem comentários

Juniper-systems Allegro DOS Manual Manual do Utilizador Página 166