Juniper-systems Allegro CX Manual Manual do Utilizador descarregar pdf (Página 256)

256 Allegro CX Owner’s Manual

Specifying GPS Receiver Port Settings

To set up the parameters on the GPS Receiver Port Settings, complete

the following steps:

Go to Start | Programs | Utilities | GPS Pod Setup, and the GPS

Receiver Port Settings screen pops up.

At the bottom of the screen, there are three function buttons:

Get Settings

Apply Settings

Reset Receiver

Get Settings

The Get Settings button is used to see the receiver’s current settings

without changing the settings. Pressing Get Settings does a search

for the GPS receiver, which can take up to one minute to ﬁ nd the

settings. Once the search is complete, the current settings for the GPS

receiver are shown.

Apply Setting

Tap on the Apply Settings button to save and apply new settings. To

make sure that your settings are applied correctly, press Get Settings

to check the parameters.

Reset Receiver

The Reset Receiver button returns the settings to their default setting.

This function enables you to start over in the event that an error was

made.

Tap on the Get Settings button and wait approximately one

minute for the settings to appear.



1 2 ... 251 252 253 254 255 256 257 258 259 260 261 ... 303 304

Sem comentários

Juniper-systems Allegro CX Manual Manual do Utilizador Página 256