Juniper-systems Allegro CX Manual Manual do Utilizador descarregar pdf (Página 255)

Allegro CX Owner’s Manual 255

Insert the stylus that is attached to the antenna mount in place of

the stylus you removed. As you place the stylus in its slot on the

Allegro, slide the metal cover up into the stylus slot so that the

stylus ﬁ ts into place.

Use two ﬁ ngers, one on each prong of the stylus, and press it

securely into place.

Make sure the rubber stylus holders are not pressed inward or

they may pop the antenna out of the stylus holder. Removing the

rubber covers to the COM ports can help make this step easier.

Place the two knobs on the end of the antenna clamp into the

screw holes located above the COM ports of the Allegro.

Tighten the thumbscrews on the antenna so that the antenna is

securely fastened into place. You want the thumbscrews to be

snug, but do not over tighten them.

Remove the protective cap from the connector labeled GPS ANT

(save the cap for future use). Screw the antenna cable into the

connector.

You have completed the steps to attach the antenna to the Allegro

GPS Expansion pod.

GPS Pod Setup Program

The GPS Pod Setup program is factory installed on your Allegro. The

program allows you to conﬁ gure the parameters of the internal GPS

receiver to accommodate the various GIS/GPS programs that run on

the Allegro.

The Allegro communicates with the internal GPS receiver via COM

3. The GPS Pod Setup program allows you to change the serial port

settings being used (i.e. baud rate, parity, stop bits), and to select

between TSIP and NMEA data output formats.

▲

1 2 ... 250 251 252 253 254 255 256 257 258 259 260 ... 303 304

Sem comentários

Juniper-systems Allegro CX Manual Manual do Utilizador Página 255