Juniper-systems TK6000 User Guide Manual do Utilizador descarregar pdf (Página 19)

Note: The device cannot be powered o while it is plugged into the

wall charger.

3. Tap Power O. A warning dialog appears. Tap OK.

To power on your Field PC, hold down the Power buon until

you see the screen light up.

Note: The Baery Seings screen will appear when you power on

your Field PC

Suspending the Device

Suspending the Field PC is dierent from powering it o.

When the device is suspended it goes to sleep, and when it

is turned back on, the device resumes where it was prior to

syspending it. Some baery power is used.

We recommend suspending your device if you plan to turn it

o for less than two weeks and if it is aached to a wall charger

when it is not being used.

To suspend your device, press the Power buon briey and

release. To resume the device from suspend mode, press the

Power buon again.

Resetting the Device

Follow the steps below to reset the Field PC:

1. Save your open les and close any running programs.

2. Press and hold the Power buon until the Power Buon

menu appears.

3. Choose Reset.

If your device locks up, you can reset the device by pressing the

Power buon for 10 seconds or until the screen goes dark. Aer

a few seconds, the device turns on again.

Ch 3 Using the Hardware 19

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 69 70

Sem comentários

Juniper-systems TK6000 User Guide Manual do Utilizador Página 19